How to Install Your UV Shield Cover — In Under 2 Minutes
Watch the short video below to see just how quick and easy installation is, then follow these three simple steps.
Your UV Shield Cover comes with everything you need right in the box — no tools, no drilling, no hassle.
Step 1: Clean the Surface Use the included alcohol prep pad to wipe down the face of your Jandy TruClear cell. This removes any dust, oils, or residue so the adhesive gets a strong bond.
Step 2: Apply the Adhesive Primer Once the surface is dry, use the included adhesive applicator pad to wipe around the outer edge where the 3M adhesive will make contact. This primer ensures a long-lasting hold through Florida heat, rain, and humidity.
Step 3: Stick It On After about 30 seconds, line up your UV Shield Cover and press it firmly into place. Hold for 15–30 seconds and you're done. TIP! Use the provided helper tool to peel the red backing off the 3M!!
That's it — start to finish in about 1–2 minutes. No contractor needed, no modifications to your equipment.
Your Jandy TruClear is now protected from UV damage for years of worry-free operation.